Ashly WR-5E 사용자 설명서

{카테고리_이름} Ashly WR-5E에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly WR-5E 6 페이지. Microprocessor based remote control

WR-5e NE Product Remote Control

1. Introduction

The WR-5e is a microprocessor based remote control unit for most Ashly NE products. Com-

patible products currently include Pema amplifiers, ne8800 and ne4800 system processors, the

ne24.24M matrix processor, and all models of the NE multichannel (four or eight channel) power

amplifiers. Additional products may become available in the future. Using Protea NE software,

six function select buttons and two parameter adjust buttons are available to control a limited range

of assigned functions within their host product. Up to four WR-5e units can be daisy-chained and

phantom powered from one NE product, and even more can be added using an in-line power supply

adapter such as the Ashly RPS-18. Note: If a WR-5e is used with a NE host product, no other serial

communications devices, including the Ashly RD-8C, may be used with that product.

The WR-5e is designed

to fit into a European electrical

wall box, but functionally is

the same as the WR-5. Elec-

trical connections to the host

unit are made using a four

conductor low gauge wire

terminated with euroblock

connectors. There is also a

two pin jumper labelled "J6"

which requires the provided

female jumper to be installed

in specific situations (see sec-

tion 2). A standard decora

plate (not included) can be

purchased separately to cover

the WR-5e electrical box and

satisfy the aesthetic needs of

the installation.

Note: Avoid static shock disruptions to connected devices by mounting the WR-5e to an earth-

grounded metal wall box, or by earth-grounding a metal decora plate. This prevents any static

discharge from flowing through the data lines.

Each of six buttons on the WR-5e can be programmed through Protea NE Software to engage

one of the following functions (if available): preset recall, preset scroll, gain control, channel en-

gage/mute, zone source selection, logic output active high, logic output active low, and matrix mixer,

with a green LED next to each button to display active status. To the right of each button is a pocket

in the mylar overlay for a paper function label to be inserted. The two other buttons are used to ad-

just function parameters, indicated by the LED display.