Cypress AN77960 매뉴얼 - 페이지 5

{카테고리_이름} Cypress AN77960에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress AN77960 13 페이지. Introduction to ez-usb fx3’s high-speed usb host controller

6. The "USBHost" project shows up in the "Projects" list.

Select the project and then select "Copy projects into

workspace". Click on "Finish".

7. After the "USBHost" project is imported into your

workspace, it appears in the "Project Explorer" pane.

www.cypress.com

Introduction to EZ-USB® FX3's High-Speed USB Host Controller

Step 2: Compile the Project

Eclipse will automatically build the project if "Build

Automatically" is enabled. The "USBHost" example has a

reverse logic on VBUS control. Below are instructions how

to change it for the DVK, and recompile the project.

From the "Project Explorer" pane, expand the "USBHost"

project, and then double-click "cyfxusbhost.h" to open the

file. Within the file, change lines 44 and 45 from

#define CY_FX_HOST_VBUS_ENABLE_VALUE

#define CY_FX_HOST_VBUS_DISABLE_VALUE

#define CY_FX_HOST_VBUS_ENABLE_VALUE

#define CY_FX_HOST_VBUS_DISABLE_VALUE

After you make the changes, it is ready to re-compile.

If "Build Automatically" is enabled, then select

Project-> Clean...

That step cleans and rebuilds the project automatically.

If "Build Automatically" is disabled, then simply select

"Project->Build Project" to build the project.

Step 3: Configure the Zylin Plug-in for GDB Debug

1. Select USBHost as the current project, then select Run-

>Debug Configurations.

Document No. 001-77960 Rev. **

(CyFalse)

(CyTrue)

(CyFalse)