Ashly ne8800 매뉴얼 - 페이지 11

{카테고리_이름} Ashly ne8800에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly ne8800 20 페이지. Network enabled dsp processor
Ashly ne8800에 대해서도 마찬가지입니다: 운영 매뉴얼 (20 페이지), 사양 (3 페이지), 운영 매뉴얼 (20 페이지)

Ashly ne8800 매뉴얼
Operating Manual - ne8800, ne4800, ne4400 DSP Processor
Metering
Three separate metering tabs are available for viewing the autoleveler, compressor/gate actions, or overall input and output
signal levels across all channels. Note: In addition to the fixed meter tabs, individual meter control objects can be placed on the
main software canvas and assigned to an input or output for a custom meter display .
Logic I/O
This tab is where the 12V digital logic I/O pins on the NE processor's back panel are assigned function . Pins designated as
logic inputs, upon contact closure with the logic ground, can recall a preset, utilize 'push to talk' to unmute a mic input and trigger
a ducker, or be assigned no function . Do not wire contact closure switches to any external ground. If a logic input pin is uncon-
nected, it will be internally pulled high . If a logic input pin is driven from an external source, any voltage from +2 .3V to +25V
will be detected as logic high . Do not exceed +25V or damage may occur to the internal circuitry.
Pins designated as logic outputs will issue either a logic high level (+12V source at 10mA) or logic low level (0V sink
at 100mA) when the GPO function (general purpose output) is selected . The high or low output state is a function of the cur-
rently loaded preset, or can be the result of a WR-5 button programmed to set the logic output to active high or active low . The
logic outputs are current limited to sourcing no more than 10mA so that these outputs can be directly wired to LED indicators .
Security
The security tab allows several levels of user ID/password protected access . The default user ID is Admin, with no pass-
word until the principle operator enters one . Up to six additional users can be added, each with their own password and access
rights assigned by the Admin .
Network Properties
This is where to find the current hardware and firmware configuration of a specific NE processor, as well as network
details. Also found here is an <Identify Device> button which will flash the Com LED on the face panel.

10. REMOTE CONTROL

10.1 WR-5 Programmable Zone Controller
The WR-5 is a microprocessor based programmable remote control unit which can be used with the NE processor . The
WR-5 is designed to fit into a standard US electrical wall box. Up to four WR-5 remotes can be phantom powered from one
NE processor . Additional remotes can be powered by using the Ashly RPS-18 remote power supply . Each of six buttons on the
WR-5 can be programmed to engage one of the following functions listed below . The up/down buttons are used to adjust the
function property .
1) Preset Recall
2) Preset Scroll Mode
3) Gain Control
4) Channel Engage/Mute
5) Zone Source Selection
6) Logic Output Active High
7) Logic Output Active Low
8) Matrix Mixer
(check the Ashly website for updated or additional remote control models)
Ashly WR-5 Programmable Controller
11