Ashly Protea NE4250 운영 매뉴얼 - 페이지 6

{카테고리_이름} Ashly Protea NE4250에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ashly Protea NE4250 20 페이지. Network enabled multi-channel power amplifiers
Ashly Protea NE4250에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지), 사양 시트 (2 페이지), 사양 (2 페이지), 운영 매뉴얼 (16 페이지), 운영 매뉴얼 (16 페이지)

페이지 인쇄

Operating Manual - NE Multi Channel Power Amplifier

Physical Description

Each model in the NE Multichannel series is 2RU. The model number is indicated in the lower left corner of the front panel.

Amplifier Front Panel

1. Mounting Holes – For rack mounting

2. Power Switch – Switches the unit on or off. Note: The power switch can be disabled from software.

3. Status LEDs – Indicates status of Power, Standby, Protect, Power Switch Disable, and Ethernet activity.

4. Air Vents – Cool air enters the sides and is blown out the front.

5. Channel Controls – Channel control area.

6. Signal LEDs – The lowest LED will begin to light when the output voltage is -18dBu below rated output. The Clip LEDs

will begin to flash when output voltage is 1/2 volt below the rated output power supply voltage.

7. Bridge – This LED indicates that the channel pair is selected to BRIDGE mode from the back panel switch, and that only

the odd input channel level control is active.

8. Temp and Current LEDs – The Temp LED indicates an excessively high operating temperature and that countermeasures

are being used to cool the amplifier. The Current LED confirms that the amplifier output is delivered to a speaker load.

9. Channel Attenuators – These control the input signal level to the amplifier. They can be disabled from software.

10. Factory Reset – To reset all internal configurations (including passwords) back to their original factory settings, press and

hold this recessed front panel momentary switch during power up until all channel LEDs are lit. Upon reset completion, the

LEDs will turn off and the amp will resume normal operating mode.

Amplifier Rear Panel

(illustration on next page)

1. Optional Network Audio – This factory option allows connection to a Dante or Cobranet audio network.

2. Optional AES3 - This slot is for factory installation of an AES3 digital audio input module.

3. Ethernet Port - This RJ45 jack is for connecting to an Ethernet network for software control.

4. Input Connector - This is used for a three wire (G, +, -) balanced input on Euroblock connectors.

5. Normal/Bridge Switch - This switches the channel pair to Bridge Mode.

6. Euroblock Speaker Connectors - Used to connect speakers to individual output channels or in bridged mode.

7. Remote Standby - These two contact closure pins are wired to a switch to remotely place the amp in standby.

8. Preset Recall - These four pins (and GND) can be wired to remote switches to recall up to four amplifier presets.