ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 제품 지원 매뉴얼 - 페이지 11
{카테고리_이름} ACR Electronics AEROFIX 406 GPS I P-ELT - REV E에 대한 제품 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 17 페이지. Personal locator beacon fcc type approval
is currently pending
ACR Electronics AEROFIX 406 GPS I P-ELT - REV E에 대해서도 마찬가지입니다: 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (14 페이지)
페이지 인쇄
Note: Use care when attaching items to your P-ELT. Clipping attachments, carabineers, rope,
webbing, etc. will all add weigh and can affect the buoyancy of the P-ELT. Your P-ELT may not
float if items have been attached to it.
To secure antenna when the holster is on your AeroFix™, be sure to deploy antenna prior to placing the
holster onto the unit. Slide the antenna through the holster to secure it to the beacon. The holster will clip
together at the bottom of holster. Rotate antenna into down position in order to wrap it around the holster to
lock it in place. Make sure the antenna runs between the two guides on the bottom of the holster. This will
prevent the antenna from slipping out of position. Finally lock the antenna into place by engaging the tab
located on the antenna into the slot provided on the top right corner of the holster. Slide it in to lock in place.
To Open the Holster, squeeze inward on the two tabs located on the bottom clip and pull up on the top of the
5.3
The AeroFix™ also comes with a bulk head mounting clip that allows you to easily mount your P-
ELT to your console or bulk head. Simply bolt the mounting clip to your desired location and slide
the P-ELT onto the clip ensuring that the bottom back of the holster slides over the clip to secure it
in place (See figure 9).
Connect GPS Interface Cable
to the bulk head mount
when P-ELT is not attached.
Removable Holster
holster. Rotate antenna up, and slide the holster off around the antenna.
Figure 8.
Figure 9.
Bulk Head Mount
10
Holster opening for the
bulk head mount.
Y1-03-0175 Rev. E