ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 제품 지원 매뉴얼 - 페이지 6

{카테고리_이름} ACR Electronics AEROFIX 406 GPS I P-ELT - REV E에 대한 제품 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 17 페이지. Personal locator beacon fcc type approval is currently pending
ACR Electronics AEROFIX 406 GPS I P-ELT - REV E에 대해서도 마찬가지입니다: 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (17 페이지), 제품 지원 매뉴얼 (14 페이지)

페이지 인쇄

ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 제품 지원 매뉴얼

SECTION 4 - OPERATION

4.1

General

The AeroFix™ 406 GPS P-ELT models are designed to be manually deployed and activated. It is

only to be activated when all other means of self-rescue have been exhausted. Activation of the

P-ELT tells Search and Rescue who you are, where you are, and that you are facing a life threatening

situation.

Self Test Button

Green & Red LED

GPS Interface

4.2

AeroFix™ 406 GPS P-ELT Emergency Activation

4.2.1 Activation

To activate your P-ELT in an emergency situation, unfasten the antenna from the case or holster and

move it into the upright position (See figure 2). Lift the holster cover revealing the P-ELT keypad

(see figure 3). Depress the "self-test" and "GPS I" or "GPS I/O" buttons simultaneously for at least

1/2 second and less than 5 seconds (see figure 4). Your P-ELT is now activated. While transmitting

your emergency signal, the red LED will flash once every 2 seconds alerting you that your P-ELT is

activated. If GPS data is present in the P-ELT via the GPS I or GPS O the red LED will turn off and

the green LED will take over flashing once every 2 seconds.

4.2.2 Activation with GPS I (P/N 2799.2 and P/N 2799.4)

The AeroFix™ 406 GPS I and GPS I/O are equipped with a GPS Interface. Prior to activating your

P-ELT you can download your GPS LAT/LON into the P-ELT using an external GPS receiver and

the GPS Interface cable provided with the P-ELT. Once your external GPS has acquired good global

positioning data, press the GPS test button for at least ½ second and no longer than 5 seconds and

your GPS data will download into the P-ELT (for full instructions see Section 4.7.2). Once you

activate your P-ELT, your GPS coordinates are included in the distress signal. The green LED will

immediately start flashing every 2 seconds to alert you that your P-ELT is activated and transmitting

your GPS coordinates with the 406 MHz signal.

Figure 1. Key Pad Functions

(P/N 2799.4 shown)

GPS Test Button

GPS I (P/N 2799.2)

GPS I/O (P/N 2799.4)

Press both test and

GPS buttons together

for 1 second to

Off Button

activate the beacon in

an emergency

Y1-03-0175 Rev. D