ASI EZFILL10-0390-6-1A-41 설치 및 유지 관리 매뉴얼 - 페이지 10

{카테고리_이름} ASI EZFILL10-0390-6-1A-41에 대한 설치 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASI EZFILL10-0390-6-1A-41 16 페이지. Soap dispenser

BATTERY REPLACEMENT INFORMATION

Battery models only

When the batteries weaken, the red indicator light will blink at a constant

rate when the user's hands are within the sensor range. The batteries must be

replaced within two weeks.

To replace the batteries:

1. Carefully open the battery box, use Phillips drive #2 to remove cover screws

(Fig. 1&2, below)

2. Remove the old batteries from carrier tray (Fig. 3)

3. Replace the used batteries with new D batteries in same polarity (Fig. 3)

NOTE: Do not mix used batteries with new ones.

4. Close the box and re-tighten the screws (Fig. 4) and reconnect battery cable.

Important: Spent batteries should not be discarded of with

normal household waste. Contact your local authority for

information on waste disposal and recycling.

Care and cleaning of chrome and special finishes- see also PCM document.

DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives,

or the like. Use of any cleaning or maintenance products containing these

substances could damage the surface of the soap dispenser. For surface

cleaning use ONLY soap and water, then wipe dry with a clean cloth or towel.

When cleaning bathroom tiles or counters, protect the soap dispenser from

any splattering of harsh cleansers.

1408201234 Rev J

05 August 2015