Cypress Semiconductor CY8CKIT-036 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Cypress Semiconductor CY8CKIT-036에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress Semiconductor CY8CKIT-036 4 페이지.
페이지 인쇄PS
Before you start, check these settings in your PSoC Development Kit
If you are using:
CY8CKIT-001
CY8CKIT-030 or
CY8CKIT-050
• Download and Install the latest kit software and
examples from
www.cypress.com/go/CY8CKIT-036
• Open the PSoC Programmer software in your computer
- Go to Start > All Programs > Cypress >
PSoC Programmer
QUICK START GUIDE
C
1/ PS
C 3/ PS
®
O
O
Check for:
Set 'VDD DIG' and 'VDD ANLG' to 3.3 V using
SW3, J6 and J7 on the CY8CKIT-001. Set J8 to VREG
Ensure the LCD Power jumper (J12) is set to ON and
the LCD is plugged into CY8CKIT-001. Connect
jumper J11 to enable power to the potentiometer
Set 'VDDD' and 'VDDA' to 3.3 V by placing jumpers in the
1-2 position of J10 and J11. Enable POT_PWR by installing
a jumper on J30 of the kit
1
3
C 5LP USERS
O
• Connect your Cypress Programmer
- If you are using a CY8CKIT-001, connect the
MiniProg3 to the PSoC processor module.
- If you are using a CY8CKIT-030 (PSoC 3) or
CY8CKIT-050 (PSoC 5LP), connect the USB cable
to the onboard programmer
Product Family Development Kit Hex File name
PSoC 1
CY8CKIT-001
CY8CKIT-001_P1.Hex
CY8CKIT-030
CY8CKIT-030_P3.Hex
PSoC 3
CY8CKIT-001
CY8CKIT-001_P3.Hex
CY8CKIT-050
CY8CKIT-050_P5LP.Hex
PSoC 5LP
CY8CKIT-001
CY8CKIT-001_P5LP.Hex
• Open the Thermal Management project hex file in the
PSoC Programmer software
• Refer to the table above to select the correct hex file for
your development kit
2
File Path
<Installation Directory>\PSoC 1 Thermal
Management EBK\<version>\HexFiles
<Installation Directory>\PSoC3_5 Thermal
Management EBK\<version>\HexFiles
4