Cypress Semiconductor CapSense Express CY3218-CAPEXP2 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Cypress Semiconductor CapSense Express CY3218-CAPEXP2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cypress Semiconductor CapSense Express CY3218-CAPEXP2 20 페이지. Evaluation kit
페이지 인쇄
Getting Started
1. Review Kit Contents
2. Explore the Board
3. Install Software
4. CY3218-CAPEXP2 Board Features
5. Tune the CY3218-CAPEXP2 CapSense Express Board
6. Create a CY3218-CAPEXP2 CapSense Express Project
7. Additional CapSense Resources
1. Review Kit Contents
Each CY3218-CAPEXP2 CapSense Express Demonstration Kit contains:
CY3218-CAPEXP2 CapSense Express Demonstration Board
■
Kit CD, which includes:
■
PSoC Programmer
❐
.NET Framework 2.0 (for Windows 2000 and Windows XP)
❐
PSoC Express 3
❐
CapSense Express Extension Pack
❐
CapSense Express Kit Documentation
❐
Retractable USB Cable (A to Mini-B)
■
PSoC CY3240-I2USB Bridge Board
■
AAA Battery
■
2. Explore the Board
Caution: Do not touch the board anywhere other than the edges or the
buttons. Touching the board in the wrong area could lead to a short and an
unresponsive board. If this happens, follow the instructions in Section 2 to
reset the power to the board.
2.1. Insert the AAA battery into the battery holder on the back of the board.
2.2. Remove the jumper from J2 (back of board, left side, center).
2.3. Slide your finger across the slider. Notice how the LEDs illuminate in a clockwise direction
as you move your finger from the left to the right across the slider.
2.4. Press the mechanical button at the bottom of the board. All four LEDs light up.
2.5. Turn the board off by replacing the jumper on J2. Note that replacing the jumper disables
battery operation.
Page 2