Asian Resources Int'l Limited MHG-T2 사용 및 관리 지침 매뉴얼 - 페이지 12

{카테고리_이름} Asian Resources Int'l Limited MHG-T2에 대한 사용 및 관리 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asian Resources Int'l Limited MHG-T2 18 페이지. Micro-hydroelectric generator

페이지 인쇄

Changing the Bearings and Seal

Apart from greasing the bearing, there are only two tasks that must be completed at

regular intervals. These are the changing of the lower generator bearing & turbine

bearing and the lower bearing seal every two years. See the section on Technical

Specifications at the end of this manual for part numbers. These are commonly

available in most countries but if in doubt contact your dealer. To replace the bearings

and seal, follow these steps:

1. Shut down the system and disconnect the power cable at the generator.

2. Drain the forebay so that the water flow stops. Do not simply block the top of the

penstock. Leave the spear valve open.

3. Wait till the penstock is drained i.e. little or no water flows out of the turbine.

4. Disconnect the turbine from the penstock

5. Unbolt the turbine and remove from the turbine stand.

6. Turn PowerPal on its side (photo A).

7. Unbolt and remove the runner (photo B).

8. Unbolt and remove the generator from the turbine casing (photo C).

9. Unbolt and remove the turbine bearing casing (photo D).

10. The turbine bearing is now visible (photo E) above the seal. Remove these using a

bearing removal tool. The seal is a black rubber ring (center of photo F) and is

there to prevent water entering the generator.

11. Before replacing the bearing ensure that the casing is clean and greased (photo F).

12. To replace the lower generator bearing, disconnect the bearing housing and use a

bearing removal tool.

13. When reassembling, make sure that all parts are correctly in place and that all

bolts are tightened.

14. After PowerPal has been securely reconnected to the turbine stand and penstock

adaptor flange the forebay is refilled and normal water flow is allowed to

continue. Wait until this occurs before reconnecting the cable and appliances.

Lower generator

bearing

Turbine bearing

Seal

PowerPal™ T2 Turgo 12