ASIT AHD-16V1D-T/RF-720P 빠른 시작 매뉴얼 - 페이지 5
{카테고리_이름} ASIT AHD-16V1D-T/RF-720P에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASIT AHD-16V1D-T/RF-720P 6 페이지. Analog hd video over fiber converters for smart hd cctv
페이지 인쇄ตั ว แปลง FO-AHD
Network Equipment สำ หรั บ กล้ อ งวงจรปิ ด
Shenzhen HUAHANDA Optical Technology Limited
The various input and output connections for our video digital optical as follows:
Video input or output: BNC Connectors.
Data Input/Output Connector:
RS-485 2-wire
Red Wire: Signal being transmitted or received (+) over fiber.
Blue Wire: Signal being transmitted or received (-) over fiber.
RS-485 Connection
Camera site
Connected the Red wire (485A) in the data cable from the transmitter to RS-485 (+) of the controlled unit
(pan/tilt, dome), and connect the Blue wire (485B) to RS-485(-)
Of the controlled unit (pan/tilt, dome).
Control site
Similarly, connect the Red wire (485A) in the data cable on the receiver to RS-485(+)
Of the controlling unit (Keyboard Controller, Matrix, DVR), and connect the Blue wire (485B) to RS-485 (-) of
the controlling unit (Keyboard Controller, Matrix, DVR).
RS-232
Green Wire: Signal being transmitted out over fiber (232R).
Yellow Wire: Signal being received in from fiber (232T).
Perplex Wire: Ground.
RS-232 Connection
Camera Site
Connect the Yellow wire (232T) in the data cable from the transmitter to RS-232 port of the controlled unit
(pan/tilt, dome), and Purple wire (GND) is used for ground connection.
Control Site
Connect the Green wire (232R) in the data cable from the receiver to RS-232 port of the controlling unit
(Keyboard Controller, Matrix, DVR), and the Purple wire (GND)
Is used for ground connection.
Indicator LEDs
The stand-alone units have integral LEDs that are used to monitor the state of the unit.
There are sixteen video LEDs, one power LED and one data LED on each unit. One,
Labeled as "power (or PWR)", lights when the video input/output signals are detected. The other one, marked
as "TD or RD", blink at the rate of the operating data.
www.asd.co.th