Ask IMPRESSION A8+ 사용자 설명서 - 페이지 7
{카테고리_이름} Ask IMPRESSION A8+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ask IMPRESSION A8+ 8 페이지. Flash upgrade user guide
페이지 인쇄FLASH UPGRADE USER GUIDE
6. SENDING THE FILE (SW&HW)
1. Flashing the SW EPROM: Type RRP;38400 and press Enter.
2. Flashing the HW EPROM: Type FPG;38400 and press Enter.
It is not necessary to use capital letters, but the command must be written exactly as
described, otherwise the projector will return "Undefined Command..". This will also happen if
you type incorrectly or try to erase text.
3. On "Hyperterminal", close the connection by clicking on the "hang up phone icon".
4. Go into "File | Properties" and press "Configure".
5.
Use the ADVANCED /SERVICE / INFO dialog-box on the projector to make sure that the
settings match those of the computer. Change the settings as described below. Confirm
with OK two times to close the dialog boxes.
6.
Re-establish the connection to the projector, so that the status bar in the lower left corner
reads "Connected".
7. Open the transfer menu and select "Send File..."
8. Browse so that the correct BIN file, which can be found on the Proxima web page under
"MLS resources Firmware.., can be selected and inserted in the file name field. It will be
explained on the web page which BIN file (HW or SW) requires the different RS232
commands (RRP or FPG). Both the SW bin and the HW bin file are 805.xxx#.bin files.
9. Set protocol to Xmodem as described in figure below. Filename should read the name of
the BIN file you have selected.
PROXIMA ASA
"Bits per second"
"Data bits"
"Parity"
"Stop Bits"
"Flow control"
7
IMPRESSION A10+/A9+/A8+
38400 Baud
8 bit
None
1 bit
None