EFX-TEK AP-8 매뉴얼 - 페이지 8
{카테고리_이름} EFX-TEK AP-8에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EFX-TEK AP-8 8 페이지.
페이지 인쇄DEBUG "Please set AP-8 segment select", CR
DEBUG "switches to OPEN, then restart", CR
DEBUG "the program."
END
Mode_Error:
DEBUG CLS
DEBUG "AP-8 is set to Record mode; please", CR
DEBUG "move PLAY/REC jumper to PLAY."
END
Accessories
750-00007
12 VDC, 1 Amp power supply; provides ample power for the AP-8
805-00002
14-inch, 3-pin extension cable; used to connect the AP-8 to the Prop-1 controller
Additional Applications
For additional ideas and application notes for the AP-8, be sure to visit our web site at the following link:
www.efx-tek.com
ChipCorder is a registered trademark of Windbond Electronics Corporation Amercia
EFX-TEK (916) 616-1658 www.efx-tek.com [email protected]
8 of 8