EG&G ORTEC 427 사용 설명서 - 페이지 18
{카테고리_이름} EG&G ORTEC 427에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. EG&G ORTEC 427 20 페이지. Delay amplifier
페이지 인쇄6-3
the malfunction. The guide plate and shield cover can be completely removed
from the module to permit oscilloscope and voltmeter observations with a mini
mal chance of accidental ly short-circuiting portions of the etched board.
The 427 may be returned to ORTEC for repair service at nominal cost. Stan
dard procedure requires that each repaired instrument receive the same exten
sive quality control tests that a new instrument receives.
6.4
Tabulated Test Point Voltages
The following voltages indicate the typical dc voltages measured on the etched
circuit board. In some coses the circuit will perform satisfactorily even though,
due to component variations, there may be voltages different from the value
given; therefore, the voltages given here should not be taken as absolute values,
but rather are intended to serve as an aid in troubleshooting.
Table 6.1 Typical DC Voltages
NOTES:
1 . All voltages were measured from ground with digital voltmeter
having input impedance of 1 megohm or greater.
2. Voltages are dc values with no input pulses.
Location
Typical
+24V Supply
24.0
+12V Supply
12.0
-12V Supply
-12.0
-24V Supply
-24.0
Qle
6.3
Qlb
5.5
Qlc
- 6.7
Q2e
- 7.4
Q2c
10.5
Q3e
- 6.7
Q3c
-23.2
Q4e
-12.3
Q4b
-11.6
Q4c
- 0.7
Q5b
-13.0
Q5c
-16.7
Q6e
0.3
Q6c
-11.8
Q7b
1 .0
Q7c
16.5
Q8b
13.8
Q8c
23.0
Voltage across R28
0
Voltage from Q8e
to Q8b
2.2