ACR Electronics Satellite2 406 제품 지원 매뉴얼 - 페이지 9

{카테고리_이름} ACR Electronics Satellite2 406에 대한 제품 지원 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics Satellite2 406 20 페이지. Emergency position indicating radio beacon

페이지 인쇄

1. Battery Replacement

4.3

Manual Deployment and Activation (Cat. 1 and Cat. 2)

4.3.1

The Satellite

™ 406 and RapidFix™ 406 (Product No. 2774 & 2776) Cat. 1 can be manually deployed by

removing the retaining pin, removing the cover, then removing the beacon from the bracket. Once

removed, either Cat.1 or Cat.2 beacons can be activated by being placed in water or by lifting the thumb

switch towards the antenna, sliding it toward the antenna and placing the thumb switch back down on the

opposite side of the EPIRB. Activating the beacon in this manner breaks off the Activation Indicator Plastic

Pin and exposes the "ON" symbol " I " on the thumb switch indicating that the beacon is turned "ON".

(See Figures 4, 5, 6 and 7)

Note: Some countries may fine vessel owners for causing false alarms. The permanent breakage of the

Activation Indicator Plastic Pin is a positive indication of a manual activation. (See Figure 7).

Alternately, the Satellite

to a vertical position, sliding it toward the antenna and pushing back down to the opposite side of the

EPIRB. Activating the beacon in this manner breaks off the "Activation Indicator Plastic Pin" and allows

the switch to properly seat, showing the " I " symbol (ON).

Figure 4

™ 406 and RapidFix™ 406 can be manually activated by lifting the thumb switch

Figure 7

Figure 5

Tab will break

when pushed

down to activate

Figure 6

Y1-03-0148 Rev. F