Ega Master Aqua Master 79908 사용 설명서 - 페이지 5

{카테고리_이름} Ega Master Aqua Master 79908에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ega Master Aqua Master 79908 12 페이지.

Before using the machine:

Open oil plug item 4 and pour in oil from oil ampul in the machine box.

Do not exert undue pressure on the machine. This will not increase its performance. Just position the bit and guide it

into the hole.

Placing the machine into the box

Make sure the adjusting sleeve is locked at the setting "rotary hammer drilling".

Side handle

This can be turned through 360°and clamped in any desired position.

Depth gauge

Press unlock button, adjust the depth gauge and release button.

Lubrication of shank end

Occasionally clean shank ends and spray sparingly with lubricant sprayer. Do not spray into the chuck.

Fig. 1

Fig. 1: Drilling in explosive surroundings

The drill must be water cooled to avoid sparks.

Fig. 2: Rotary hammer drilling

Pull back the adjusting sleeve and turn it clockwise to lock. Do not use the quick-release chuck at this setting because

drills and tools will be damaged.

Fig.3: Pull back the locking sleeve and insert the drill. Turn the locking sleeve until it snaps back into the outset

position. Press the machine against the work surface before switching on otherwise the tool will not hammer. If the drill

sticks in the hole, withdraw and reinsert it several times when drilling.

OPERATION INSTRUCTIONS

Fig. 2

Fig. 3

Fig. 4

Fig. 5