Asko D1796FI 설치 지침 매뉴얼 - 페이지 9

{카테고리_이름} Asko D1796FI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko D1796FI 14 페이지. Standard dishwashers
Asko D1796FI에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (2 페이지), 설치 및 사용자 지정 (4 페이지), 기획 및 디자인 매뉴얼 (19 페이지), 사용 및 관리 매뉴얼 (12 페이지), 기획 및 디자인 매뉴얼 (15 페이지)

페이지 인쇄

FASTENING THE DISHWASHER TO THE CABINET

It's necessary to fasten the dishwasher to the cabinet

so it won't tilt when the door is opened or if something

heavy is placed on the door. Use only the stainless

steel screws provided with the machine.

Use option A for U.S. or European standard

installations. Use option B only for European

standard installations.

Cover the screw heads with the

plastic plugs provided with the

machine.

When the machine is properly

attached, check that the feet are

tight against the floor and that the

machine is level.

REPLACING THE TOE KICK BRACKETS

After you replace the guard plate (see page 7), you need

to replace the toe kick brackets. While holding the spring

tab on the base pan toward the outside of the machine,

slide the bracket into the slots on the guard plate and

work it between the guide slots on the base pan.

Adjusting the Bracket Depth

You will have to adjust the bracket depth to allow for the

thickness of the toe kick. To do this, first measure the

thickness of the toe kick. Then press the spring tab on

the sides of the base pan toward the outside of the

machine and carefully pull or push the bracket to the

required depth less the thickness of the toe kick.

INSTALLING THE TOE KICK

Once you have the toe kick bracket in place, you can

install the toe kick, as follows:

If you have not done so, remove the toe kick and felt

insulation from the brown paper packaging.

Lay the insulation on the back side of the toe kick to

make sure it fits properly.

Peel the adhesive protection strip off the insulation

and press it firmly to the back side of the toe kick,

making sure you don't cover any slots on the toe

kick.

Positioning the notches on the toe kick at the edge

of the access panel, slide the toe kick up behind

the access panel then let it slide to the floor.

Screw the toe kick to the toe kick brackets.

NOTE:

Mounting

Screws

NOTE:

Adjusting the Toe Kick Height

on D1996FI and D1976CSTM

These models come with two toe kicks. Use the

mounted toe kick for shorter kick areas and both toe

kicks for taller installations.

The toe kick has extended screw slots that allow you to

adjust the height. Position the toe kick so it touches the

floor and tighten the screws.

Option A can be used for U.S. or European

installations. Use option B for European

standard installations only.

When it is not possible to attach the dishwasher

to the cabinet, you should install tip guards. (See

"Tip Guards" on page 2.)

Make sure the toe kick bracket is securely inside

the guides on the base pan.

Extended screw slots

Guard plate

Page 9