Asko D3250FI 설치 지침 매뉴얼 - 페이지 4
{카테고리_이름} Asko D3250FI에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko D3250FI 12 페이지. dishwaher
페이지 인쇄
CORNER INSTALLATION
If the dishwasher is installed in a corner, there must be
a minimum clearance of 2" (50 mm) from the side wall
so the door can open.
2" clearance
WATER SUPPLY
WARNING! Plumbing connections must comply with
applicable sanitary, safety and plumbing codes in your
area.
The machine can be connected to either a hot or cold
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
The dishwasher comes with a 6-foot PEX water supply
line that has a 3/8" NPT female connection.
E
I
ASY
NSTALL
PEX tubing with 3/8"
compression fitting
PEX tubing has a 95-year
spec life. Fits American
dishwasher water supply
valves.
Drain hose boot
Ready to be cut to desired
drain connection. Only
one clamp required.
Electrical cord
110-120 volts, 15/20 amp
cord supplied with unit.
WARNING!
Do not use an extension cord for this appliance.
Page 4
CONNECTIONS
INSTALLING THE TIP GUARDS
(OPTIONAL)
When it is not possible to fasten the dishwasher to the
cabinet, you should install tip guards to prevent the
machine from tipping when the door is opened. The tip
guards can be attached either to the floor or the wall.
The tip guards should be mounted behind the machine,
19" (483 mm) apart (measuring center to center) and
18-1/2" (470 mm) from the front of the machine. (Note:
This measurement could vary, depending on the
thickness of the custom panel, if any.)
Rear
We recommend that you install tip
guards when it isn't possible to fasten
the dishwasher to the cabinet.
After determining where the water supply line will enter
under the sink, drill a 1-1/2" to 2" (38 mm to 50 mm)
access hole and run the line to the approximate inlet
valve location shown in the figure below. The water line
inlet valve is on the right rear of the machine.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location, such as, beneath the sink.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At last 3 gallons (12
liters) per minute must be able to pass through the
line. The water pressure should be 18-176 psi.
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
(1) Water supply
(2) Water supply valve
(not supplied)
Be sure to run the PEX tubing through the hole
NOTE:
to sink compartment before moving the
dishwasher into position.
Tip Guards
(P/N 8070851)