Bluerock Tools CG-30 운영 매뉴얼 - 페이지 12
{카테고리_이름} Bluerock Tools CG-30에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bluerock Tools CG-30 18 페이지. Track torch / burner machine
페이지 인쇄C G - 3 0
T R A C K
T O R C H
Ø Ensure the torch tip is in a raised position so it will not get damaged when lifting up the machine
or putting down the machine.
Ø If transporting inside a vehicle, it is recommended to transport it on its side so as to avoid the
item falling over.
Ø DO NOT carry the machine by the cord.
Ø DO NOT allow the cord or plug to drag along the floor when transporting.
RUNNING THE MACHINE FOR STRAIGHT LINE CUTS
Ø Do all pre-operational and operational safety checks from Chapter 1.
Ø Consider your security and stability as well as the orientation of the machine in the work area.
o
o
Ø Ensure the work surface and machine are free of debris, oil, etc.
Ø Set the start/stop lever in the stop position.
Ø Set up cutting tracks. Ensure they are straight.
o
Ø Place machine at the start of the cut ensuring the wheels of the machine are set in the V in the
cutting tracks.
o
Ø Select appropriate size torch tips for the application. Install tip.
Ø Connect applicable gas lines.
o
o
o
Ø Select the neutral position in the machine directional toggle switch.
Ø Securely fasten the plug into the machine and lock in using the plug screw.
Ø Plug the cord into the external power source.
Ø Ensure the torch holder is not too close to the side of the heat guard. It should be set at least
4"s away from the side of the heat guard.
Ø Adjust the side knobs to raise the torch tip to a suitable level for lighting.
Ø Light the torch flame (see section below on proper lighting of torch flame).
Ø Adjust the side knobs a suitable level for cutting though the material.
B U R N E R
M A C H I N E
Consider the work surface material, condition, strength, density and rigidity. These
factors directly affect the tools use.
Ensure the piece being cut will be stable after the cut has been made.
NOTE: It may be necessary to mechanically clamp or secure the tracks by some method
depending on the application.
NOTE: Make certain the wheels are free and not in the lock position with the wheel
"wing-nut" slightly loose.
Make certain they are properly secured and there are no leaks. It is highly recommended
that leak testing be performed on the system prior to using the machine.
Ensure the lines are long enough to complete the cut you are planning.
ALWAYS use gas tank cylinders with properly outfitted regulators/flowmeters.
9