Bluerock Tools CG-30 운영 매뉴얼 - 페이지 16
{카테고리_이름} Bluerock Tools CG-30에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bluerock Tools CG-30 18 페이지. Track torch / burner machine
페이지 인쇄C G - 3 0
T R A C K
T O R C H
Troubleshooting
No
Problem
1
No power to
the machine
2
The machine
speed can't be
adjusted
3
Leak gas
and/or flame in
the joint of
torch and
torch cutting
tip.
4
The flame
goes out as
soon as the
oxygen valve
is opened
5
The steel plate
can't be cut
through
6
The cutting is
not straight
enough.
B U R N E R
M A C H I N E
SERVICING SHOULD ONLY BE DONE BY A QUALIFIED TECHNICIAN.
DON'T FORGET TO UNPLUG POWER TO UNIT PRIOR TO SERVICE!
Cause
1. Machine is not plugged in or issue with power.
2. The fuse is burned.
3. The wires in the control panel, plug or switch
were disconnected or damaged.
1. Variable speed switch defective.
1. The torch holder inlet is damaged.
2. There is copper burr or materials on the
surface of the torch tip.
The cutting oxygen leaked into the preheating
oxygen area.
1. Copper stain or useless materials on the inner
part of torch
2. The smaller cone of torch cutting mouth was
stuck with some with material or was damaged.
1. The torch cutting-tip is too small.
2. The flame frequency is not strong enough
3. Low pressure for cutting oxygen
4. The hole channel of cutting mouth may be
jammed
5. The cutting oxygen is not pure.
6. The cutting oxygen was leaked into the
preheating oxygen hole channel.
1. The steel plate was deformed.
2. The flame line was not straight.
3. Uneven guide channel
4. The torch was poorly fixed and can be moved.
Note
1. Check and repair the circuit.
2. Change the fuse
3. Fix the disconnected wire or replace control panel
components.
1. Repair the variable speed piece
1. Softly grind the torch cone with small sand paper to clean
out the burr.
2. Clean the material on the cutting tip. Softly grind the
surface with small sand paper. Change the cutting tip if it is
badly damaged.
1. Softly grind the most inner part of torch holder with sand
paper to clean out the debris or damage.
2. Softly grind the smaller surface of the cutting mouth.
Change the cutting mouth if it is serious damaged.
1. Choose the cutting tip spec according to the cutting
thickness.
2. Increase flame frequency properly.
3. Properly increase the cutting oxygen to ensure the enough
flow speed of cutting oxygen.
4. Clean the useless materials in the torch cutting mouth with
cutting pin.
5. Use oxygen with more than 95% purity.
6. Clean the useless materials on the cutting mouth and
torch, repair the damaged surface and change cutting mouth
if needed.
1. Use flat steel plate and calibrate it before cutting.
2. The torch should have an 90
tightly fixed. Clean the useless materials in the torch cutting
mouth with cutting pin.
3. Calibrate the guide of the machine
4. Tighten all connections.
13
4
Chapter
Solution
o
angle with the steel plate and