Egardia 8718347930073 설치 매뉴얼 - 페이지 3
{카테고리_이름} Egardia 8718347930073에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Egardia 8718347930073 7 페이지.
페이지 인쇄INSTALLING THE SMOKE DETECTOR
The installation process of the Egardia smoke detector consists of four easy steps.
STEP 1.
CHECK CONTENTS
STEP 2.
ADD TO ALARM SYSTEM
MOUNT SMOKE
STEP 3.
DETECTOR
STEP 4.
CHECK AND TEST
STEP 1: CHECK CONTENTS
Check the contents of the packaging for the following parts:
1.
Smoke detector with mounting plate
2.
Bag containing screws and plugs
3.
3 x 1,5V AA alkaline batteries
STEP 2: ADD TO ALARM SYSTEM
You are now about to register the smoke detector with your Egardia alarm system.
1.
Open the smoke detector by removing the two screws at the top and bottom Open the smoke
detector and insert the batteries into the battery compartment. Ensure that the battery
polarization is correct. When the batteries are installed correctly the smoke detector will beep
twice and the status indicator will start to flash.
2.
Within 10 minutes the smoke detector will beep once to indicate that it has started the
initialization process. The sensor will take various readings of the surrounding environment and
memorizes the results. The initialization process can take a few minutes. Upon completion of
the initialization process, the smoke detector will beep twice and the status indicator will stop
flashing. The smoke detector has stored the environmental information and is ready for
installation. Please note! If the initialization process of the smoke detector is still not finished
after 20 minutes and the smoke detector has not beeped twice the initialization process has
failed. Remove the batteries of the smoke detector, wait for 1 minute and then replace the
batteries. The smoke detector will start the initialization process again.
3.
Ensure at your gateway that the alarm is turned off. The top indicator light (Status) and the
bottom indicator light (Online) are lit green.
4.
Press the "Reset" button at the side of the gateway for at least 5 seconds. The top indicator
light (Status) of your gateway flashes green to indicate it is searching for new accessories.
5.
Press the register button of the smoke detector. The gateway beeps once and the smoke
detector beeps twice to indicate the smoke detector is successfully registered. The gateway
and the smoke detector beep twice to indicate the smoke detector has already been
successfully registered.
6.
Press again the "Reset" button at the side of the gateway for at least 5 seconds if no more
accessories are being added. The gateway returns to normal operation.
7.
Login to your Egardia account and go to the tab "Alarm system". The registered smoke
detector will appear after a few minutes.
8.
Rename the smoke detector for easy recognition.
2
CHECK THE CONTENTS OF THE BOX
REGISTER THE SMOKE DETECTOR
WITH YOUR EGARDIA ALARM SYSTEM
DETERMINE THE LOCATION AND
MOUNT THE SMOKE DETECTOR
CHECK AND TEST THE SMOKE
DETECTOR