D&B xC 16C 매뉴얼 - 페이지 7

{카테고리_이름} D&B xC 16C에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. D&B xC 16C 12 페이지. Manual 1.3 en

Connector wiring

d&b 16C Manual 1.3 en

2.2. Connections

16C cabinets are fitted with a 4-pole Phoenix Euroblock connector

block accepting a 2-pole Phoenix Euroblock screw terminal

connector (cross-section up to 4 mm

uses the pin assignments 1: + and 2: —. Pins 3 and 4 are not

connected.

In addition, an NL4 M connector is provided using the pin

assignment 1+/1–.

NOTICE!

Only operate d&b loudspeakers with a correctly configured d&b

amplifier, otherwise there is a risk of damaging the loudspeaker

components.

Applicable d&b amplifiers:

10D/30D/D6/D12/D20/D80.

Application

Setup

16C

For applicable amplifiers, the controller setup is available in Dual

Channel and Mix TOP/SUB mode.

For acoustic adjustment the functions CUT, HFA and CPL can be

selected.

CUT circuit

Set to CUT, the cabinet low frequency level is reduced. The

cabinets are now configured for use with actively driven d&b

subwoofers.

/AWG 11). The connector

Cabinets per

channel