ACR Electronics HRU 설치 절차 매뉴얼 - 페이지 16

{카테고리_이름} ACR Electronics HRU에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics HRU 18 페이지. Acr electronics hydrostatic release unit installation manual

페이지 인쇄

SECTION 8 – INSTALLING THE HRU IN A CAPSULE

BRACKET

The ACR capsule bracket is a

discontinued product that looks like this:

Contents of the HydroFix™ HRU Kit that you will need:

HydroFix™ Replacement

Hydrostatic Release Unit (E)

Capsule design release rod (B)

Keyed bracket adapter (D)

Large cotter pin (H)

HRU expiration label (K)

Instructions:

1.) Remove the front cover and carefully release

the EPIRB from the bracket.

2.) Remove the old HRU unit and rod from the

bracket by pressing the spring release back

and sliding the old HRU up and out of the

bracket.

3.) Take the capsule design release rod (B) and

place on top of the small rod on the HRU

aligning the two sets of holes on the base. (see

Figure A).

4.) Place large cotter pin (H) through the two

holes, securing the two rods together.

5.) Place keyed bracket adapter (D) on the bottom of the HRU. This

part is keyed so that it will fit together only one way. Turn to the right

until it snaps into place.

6.) Mark the expiry date on the HRU according to the instructions in

Section 3.

Y1-06-0209G

Figure A