Asko D5132XXL 설치 지침 매뉴얼 - 페이지 10
{카테고리_이름} Asko D5132XXL에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko D5132XXL 16 페이지. Xxl dishwasher
페이지 인쇄MOVING THE MACHINE INTO PLACE
WARNING!
Make sure you put the protective slides on the legs to
prevent damaging the floor when you slide the unit into
place (see page 9).
1. Position the machine in front of the cabinet opening.
2. Make the height adjustment while the dishwasher is
in front of the opening.
3. Pull out the drain hose to ensure there are no sharp
bends.
4. Start to feed water and drain lines and electric cord (if
necessary) into the access hole in the cabinet.
5. Gently slide the unit into the dishwasher opening. As
you do this, feed the drain line and inlet hose into the
access hole in the side of the cabinet.
CONNECTING THE ELECTRIC CABLE
If the cord is not long enough, or if a hard-wire installation
is needed, follow the steps below to complete the
electrical connection.
WARNING!
Before starting this procedure, be sure the power is turned
off at the breaker/fuse box.
1.
Connect supply cable with
a UL-listed strain relief
bushing (if nonmetallic
cable is to be used).
2.
Connect branch circuit white
lead to N lead on filter.
3.
Connect branch circuit black
lead to L lead on filter.
As you slide the unit into place, feed the drain line and
inlet hose into the access hole in the side of the cabinet.
Warning!
Be careful of sharp edges.
4.
Connect ground wire to ground connection screw on
the bottom.
NOTE:
When doing a hard-wire installation, you must remove the
supplied power cord.
Customer Care Center
1-800-898-1879
www.askousa.com
Page 10