d&b audiotechnik 10AL-D 매뉴얼 - 페이지 6

{카테고리_이름} d&b audiotechnik 10AL-D에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik 10AL-D 12 페이지. 2-way loudspeakers
d&b audiotechnik 10AL-D에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)

페이지 인쇄

Fig. 2: Connector wiring

Fig. 3: Cover plate and rubber grommet

Fig. 4: Installing the fixed cable connection

2.2. Connections

The cabinets are fitted with a pair of NL4 connectors and a two

pole screw terminal block (ST). All four pins of both NL4

connectors are wired in parallel. The cabinets use the pin

assignments 1+/1–. Pins 2+/2– are designated to active

subwoofers.

Cabinets with the weather resistant option (WR) are equipped with

a fixed input cable (PG type, H07-RN-F, 2 x 2.5 mm

standard length 5.5 m (18 ft).

Pin equivalents of the applicable connector options are listed in the

table below.

NL4

Brown (+)

Blue (–)

Fixed cable connection

The 10AL and 10AL-D loudspeakers are each supplied with a

cover plate [1] and a rubber grommet feed through [2]. For

indoor operation, these items can be used to hide the connector

panel, if required. For unprotected outdoor operation, the

connector panel must be covered, i.e. both items must be used to

achieve an IP degree of protection of IP34.

To install the fixed cable connection, proceed as follows:

Tools required: Philips screw driver (#PH2).

1. Prepare the rubber grommet and the connection cable.

2. Remove the knockout opening in the cover plate and attach

the rubber grommet correspondingly.

3. Insert the connection cable through the rubber grommet and

connect the cable wires to the screw terminal.

Þ Observe the correct polarity!

4. Undo the four screws of the connector panel.

5. Push the cover plate towards the connector panel until it fits

into place.

6. Finally fix the cover plate together with the connector panel

using the four screws.

(AWG 13),

1–

–

n.a.

d&b 10AL/10AL-D Manual (1.2 EN)

2–

n.a.