d&b audiotechnik Ci7-TOP 사용 설명서 - 페이지 6

{카테고리_이름} d&b audiotechnik Ci7-TOP에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik Ci7-TOP 8 페이지.

Fig. 4: Controls on C7-TOP

controller module

Fig. 5: Ci7-TOP isobar diagrams

Ci7-TOP Manual

Operation with E-PAC (version 3 with display only)

Selecting C7-TOP mode enables the E-PAC to drive one Ci7-TOP

loudspeaker. LO IMP mode allows the E-PAC to drive two Ci7-TOP

loudspeakers with a 6 dB reduction of input level to the speakers.

The CUT and HFA settings are available. The characteristics of the CUT

and HFA settings are explained in the previous section "Operation with

D6 or D12 - Controller settings".

Up to two Ci7-TOP cabinets can be driven by each P1200A power

amplifier channel fitted with a C7-TOP controller module. Fitting one

C7-TOP and one subwoofer controller module allows a single

mainframe to drive two Ci7-TOP and two active subwoofer cabinets.

The CUT and HFA settings are available. The characteristics of the CUT

and HFA settings are explained in the previous section "Operation with

D6 or D12 - Controller settings".

The diagrams below show dispersion angle vs frequency plotted using

lines of equal sound pressure (isobars) at –6 dB and –12 dB. The

nominal 75° horizontal dispersion is maintained from 17 kHz down to

600 Hz.

(2.1 EN)

Page 6 of 8