d&b audiotechnik xS Series 매뉴얼 - 페이지 7

{카테고리_이름} d&b audiotechnik xS Series에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik xS Series 12 페이지.
d&b audiotechnik xS Series에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지)

페이지 인쇄

Faston type connector, male single PG (standard), dual PG

(optional)

d&b 8S Manual 1.4 en

WR option (Weather Resistance)

A number of d&b loudspeakers are available in special options

suitable for different types of installed applications and

environmental conditions. The following options are available for

the 8S loudspeaker:

▪ Weather resistant (WR): This option is suitable for outdoor use.

The cabinets have an impact and weather protected black PCP

(Polyurea Cabinet Protection) finish.

▪ Sea water resistant (SWR): This option is suitable for outdoor

use, especially in wet and acid or salty environments.

WR cabinets are equipped with a recessed connector panel

including a Faston type connector (2 x 6.3 mm, female). A cover

plate which accepts single or dual PG cable glands (Type PG13.5

for cable diameters from 6 - 12 mm) is enclosed, as shown in the

graphic opposite.

NOTICE!

The WR option enables operation of loudspeakers in changing

ambient conditions, however it is not intended to enable

permanent, unprotected operation of loudspeakers outdoors.

▪ Provide an additional cover over the loudspeakers.

▪ Aim the cabinets either horizontally or with a downward tilt.

To install the fixed connection cable, please proceed as follows:

Tools required: Screw driver (#T20).

Note: Observe the correct polarity of the cable

Brown (+) / Blue (—).

1. Insert the connection cable through the PG screwing and

connect the male connector to the female connector.

2. Push the cover plate towards the connector panel until it fits

into place.

3. Fix the cover plate to the connector panel using the four

countersunk screws.

2.3 Operation

NOTICE!

Only operate d&b loudspeakers with a correctly configured d&b

amplifier, otherwise there is a risk of damaging the loudspeaker

components.

Applicable d&b amplifiers:

10D/30D/D6/D12/D20/D80.

Application

Setup

Within applicable d&b amplifiers, the controller setup is available

in Dual Channel or Mix TOP/SUB mode.

Cabinets per

channel