d&b audiotechnik Y7P 매뉴얼 - 페이지 6

{카테고리_이름} d&b audiotechnik Y7P에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik Y7P 12 페이지.

pas s i ve

c r os s over

Connector wiring

2.2. Connections

The cabinets are fitted with a pair of NLT4 F/M connectors. All

four pins of both connectors are wired in parallel. The cabinets use

the pin assignments 1+/1–. Pins 2+/2– are designated to active

subwoofers. Using the male connector as the input, the female

connector allows for direct connection to a second cabinet.

The cabinets can be supplied with NL4 M or EP5 connectors as an

option.

Pin equivalents of the connector options are listed in the table

below.

NLT4 F/M

NL4 M

EP5

NOTICE!

Only operate d&b loudspeakers with a correctly configured d&b

amplifier, otherwise there is a risk of damaging the loudspeaker

components.

Applicable d&b amplifiers:

D80/D20/D12/D6/10D/30D.

Application

Setup

Y7P

Y10P

For applicable amplifiers, the controller setups are available in

Dual Channel and Mix TOP/SUB mode.

For acoustic adjustment the functions CUT, HFA and CPL can be

selected.

CUT circuit

Set to CUT, the cabinet low frequency level is reduced. The

cabinets are now configured for use with actively driven d&b

subwoofers.

1–

2–

n.a.

Cabinets per

channel

d&b Y7P/Y10P Manual 1.2 en