d&b audiotechnik Y8 매뉴얼 - 페이지 7

{카테고리_이름} d&b audiotechnik Y8에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik Y8 12 페이지.

Frequency response correction of the CPL function

Frequency response correction of the HFC function

d&b Y8/Y12 Manual 1.2 en

The transition from Line to Arc configuration within the array is

made according to the splay progression but may allow for certain

deviations due to the wiring of the cabinets in groups of up to two.

2.3.1 Controller settings

For acoustic adjustment the functions CUT, CPL and HFC can be

selected.

CUT mode

Set to CUT, the low frequency level of the cabinets is reduced. The

Y8/Y12 array is now configured for use with the d&b Y-SUB or

J-SUB subwoofers.

CPL function

The CPL (Coupling) function compensates for coupling effects

between the cabinets of an array. CPL begins gradually around

2 kHz, with the maximum attenuation below 100 Hz. As coupling

effects increase with the length of the line array, the CPL function

can be set to dB attenuation values between 0 and –9. With

higher attenuation values the corner frequency of the filter shifts

towards lower values.

Positive CPL values create an adjustable low frequency boost (0 to

+5 dB) and can be set when the system is used in full range mode

without subwoofers.

Note: Make sure that all cabinets within the line array are

operated with the same CPL setting.

HFC function

Selecting the HFC (High Frequency Compensation) function

compensates for the loss of high frequency energy due to air

absorption when loudspeakers are used to cover far field listening

positions.

The HFC function has two settings (HFC1 and HFC2) for different

distances the cabinets need to cover. The settings should be used

selectively; HFC1 for cabinets covering distances larger than 25 m

(82 ft) and HFC2 for those covering distances larger than 50 m

(164 ft).

The compensation is adjusted for a typical relative humidity of

40 %. With lower humidity the absorption by air increases

therefore the distances where the respective HFC setting provides a

correct equalization are shorter than indicated above.

Using the HFC function provides the correct sound balance

between close and remote audience areas, whilst all amplifiers

driving the array can be fed with the same signal.