d&b audiotechnik Yi-SUB 매뉴얼 - 페이지 6

{카테고리_이름} d&b audiotechnik Yi-SUB에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik Yi-SUB 11 페이지.

Step 1

Step 2

Installing the fixed cable connection

NL4 cable connection with cover plate [1]

Step 3

Fixed cable connection

The Yi-SUB loudspeaker is supplied with a cover plate [1] and a

rubber grommet feed through [2]. For indoor operation, these

items can be used to hide the connector panel, if required. For

unprotected outdoor operation, the connector panel must be

covered, i.e. both items must be used to achieve an IP degree of

protection of IP34.

To install the fixed cable connection, proceed as follows:

Tools required: Philips screw driver (#PH2).

1. Remove the knockout opening in the cover plate [1] and

attach the rubber grommet [2] correspondingly.

2. Insert the connection cable through the rubber grommet.

3. Undo the four screws of the connector panel.

4. Connect the cable wires to the screw terminal.

Þ Observe the correct polarity!

5. Push the cover plate towards the connector panel until it fits

into place.

6. Finally fix the cover plate together with the connector panel

using all screws.

Step 4/5

NL4 connection with cover plate

The two NL4 connector sockets of the cabinet's connector panel

are located in a recess to allow the use of the cover plate [1]

together with NL4 cable connectors, as shown in the graphic

opposite.

Note: Neutrik NL4FC type connectors must be used for this

option.

The cover plate is equipped with two knockout openings to allow

daisy chaining of the loudspeaker.

To use the NL4 connection, proceed in the same manner as

described in the previous section .

Step 6

d&b Yi-SUB Manual 1.3 en