d&b audiotechnik Z5160 설치 지침 - 페이지 5

{카테고리_이름} d&b audiotechnik Z5160에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. d&b audiotechnik Z5160 6 페이지. Load adapter

페이지 인쇄

[B]

Fig. 6: B2212 Quick lock mechanism

Z5159

Z5160

FLYING FRAME

FRONT

INSERT

SELECT

SECOND PIN

LIFTING POSITION

BEFORE LIFTING

AND INSERT PIN

Fig. 7: Direction label of the Load adapter

Fig. 8: Hole 20 (1/1)

Fig. 9: Hole 20 + 1/4

Fig. 10: Hole 20 + 1/2

Z5160 Mounting instructions

6.1. Quick lock mechanism of the locking pins

Pressing the button [B] releases the locking mechanism allowing

[B]

insertion and retraction thru the load adapter and the flying frame.

Releasing the button [B] after the pin is fixed in place the locking

mechanism will be locked.

Ensure that the pin is locked. A groove [G] (see Fig. 6) in the bolt of the

pin indicates that it is properly locked.

6.2. Fitting to the Z5159 Flying frame and adjustment

The appropriate hole in the top row of the frames bars to achieve the

Z5159

Z5160

desired vertical aiming of the array is calculated using the d&b Q-Calc

FRONT

Array software.

INSERT

SELECT

SECOND PIN

LIFTING POSITION

BEFORE LIFTING

AND INSERT PIN

Depending on the chosen lifting device – 2t shackle or Rota Clamp – the

Load adapter is to be placed on the centre bar of the Z5159 Flying

frame while the chosen suspension point is facing towards the back of

the flying frame (see Fig. 7).

According to the calculated value given by Q-Calc the Load adapter

needs to be adjusted as following:

Example 1:

Hole 20 is calculated - Fig. 8.

1. The Load adapter is to be placed and moved as long as the hole of

2. The second locking pin is to be fixed to the resulting "free" hole ( ).

Example 2:

Hole 20+1/4 is calculated - Fig. 9.

1. Again the Load adapter is to be placed and moved as long as the

2. Now the Load adapter is to be moved towards the back of the

3. The second locking pin is to be fixed to the resulting "free" hole ( ).

The other two possible holes (20+1/2 - Fig. 10 and 20+3/4 - Fig. 11)

are adjusted the same way as decribed in example 2.

Fig. 11: Hole 20 + 3/4

(1.0E)

Assembly

the bottom row marked with "1/1" is in line with hole 20 of the bar

of the flying frame and to be fixed with the locking pin ( ).

hole of the bottom row marked with "1/1" is in line with hole 20 of

the bar of the flying frame.

frame as long as the hole of the bottom row marked with „1/4" is in

line with the nearby hole of the bar of the flying frame and to be

fixed with the locking pin ( ).

Page 5 of 6