D&D Technologies Lokk-Bolt 피팅 지침

{카테고리_이름} D&D Technologies Lokk-Bolt에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. D&D Technologies Lokk-Bolt 2 페이지. Security drop bolt
D&D Technologies Lokk-Bolt에 대해서도 마찬가지입니다: 피팅 지침 (2 페이지)

페이지 인쇄

FITTING INSTRUCTIONS

Lokk-Bolt is supplied and configured to suit a right-hand

gate when viewed from inside (house side).

Important: In order to re-configure Lokk-Bolt for left-hand

gates, please read the instructions overleaf entitled

'Re-configuring the Lokk-Bolt for Left-Hand Gates'.

Tools required: Electric drill, 5/8"–3/4" (16–19mm)

drill-bit (to suit masonry), 5/32" (4mm) drill-bit (for

pilot holes in thick steel), Phillips No. 2 screwdriver (hand

& powered types), level, pencil.

1. Ensure all gates are level to the finished ground

surface. The Lock Housing (see right) on the Lokk-Bolt

should be key-locked into the upper "detent" groove*.

Locate the Lokk-Bolt on the inside of the gate (house

side), positioning it so the bottom of the bolt rests on the

ground surface (concrete, tiles, stone etc). The Lokk-Bolt

must be held or clamped so that the two mounting

brackets sit firmly against the gate frame.

2. Mark a circle on the ground surface around the

bottom of the stainless steel rod. Drill this hole 5/8"–

3/4" (16–19mm) to a suitable depth. (The hole will

need to be larger if a pipe is to be inserted.)

3. Locate the Lokk-Bolt back onto the gate, with

the rod inserted into the hole to the required

depth. The position of the Lower Bracket is

important; it should be as low as possible, but no

further from the Lock Housing than the maxi-

mum measurements shown in Diagram B over-

leaf. Use a pencil to mark inside the slots of both

brackets for the mounting screws, using the

brackets as templates.

4. Remove the Lokk-Bolt. The lock is supplied

with self-drilling screws, but, if fixing to thick

steel gates, drill 5/32" (4mm) pilot holes through

the center of the marked slots. (For wooden

gates, consult your local hardware expert for

appropriate wood screws.) Reposition the Lokk-

Bolt onto the gate and fasten using the screws

provided.

5. Insert the four Dress Caps supplied into the screw slots.

The Lokk-Bolt is now ready for use.

LOCK

HOUSING

(BRACKET)

Upper

Detent

Groove

(obscured)

LOWER

BRACKET

DIAGRAM A

The Lokk-Bolt has two detent grooves, both of which

are for either retaining or locking the rod in place. The lower

groove holds the Lokk-Bolt off the ground and the upper

groove locks the rod into place for security.

Dress

Caps

Rod

Hole depth recommended to be

minimum of 1.1/4" (30mm)