D&D Technologies CodeLocks KL1100 프로그래밍 및 작동 지침 - 페이지 8
{카테고리_이름} D&D Technologies CodeLocks KL1100에 대한 프로그래밍 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. D&D Technologies CodeLocks KL1100 9 페이지.
페이지 인쇄20% - 50%
<20%
Battery Failure
After a Code is entered, the red LED will flash 3 times to indicate low power. The KitLock will operate for a further 100 openings.
The batteries should be replaced as soon as possible.
Battery Failure Override
The KL1100 KeyPad has been designed so that a mobile power bank can be used to open the lock to allow access to the batteries so
they can be replaced should they fail.
1. Plug the power bank into the micro USB port at the bottom of the lock, it will power up.
2. Enter the Master Code.
3. Whilst the lock is in an unlocked state, open the cabinet and replace the batteries found in the latch unit.
Factory Reset
Master Code Unknown: If the Master Code has been forgotten, the manual method must be used.
Keypad Method (Private & Public Function)
#Master Code
●
99●99
● ●
Example: #11335577
●
99●99
Result: All User Codes will have been deleted, the Sub-Master and Technician Codes disabled and all settings reverted to factory
default. The Master Code will be 11335577 and a single User Code of 2244 will be available. The lock will be in Private Function.
Manual Method
1. Open battery compartment
2. Remove a single battery
3. Press & hold pinhole reset button with a wire pin
4. Replace battery, whilst continuing to press the reset button
5. Release the reset button
6. Within three seconds, press the reset button three times
https://codelocks.zohodesk.eu/portal/en/kb/articles/kl1100-keypad
● ●
●
●
●
●
●
●