D&R ClubMix 매뉴얼 - 페이지 10
{카테고리_이름} D&R ClubMix에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. D&R ClubMix 20 페이지.
페이지 인쇄11.6 AUX RETURN
The aux return is a stereo jack socket. The tip goes to the left program buss and the ring to the right program
buss.
A mono signal source has to feed both tip and ring simultaneously.
WARNING If a mono jack is used in the aux return jack, the right input will be shorted to ground and there will
be no signal in this return.
11.7 AUX SENDS
The aux sends are ground compensated output jacks wired as balanced outputs.
The tip is hot, the ring is the ground compensation, the sleeve is ground.
Output level is +4dBu at an impedance of 100 ohm.
11.8 INSERTS
The inserts are send and return signals on one jack. The ring is the send at 0dBu level at 100 Ohm. The tip is
the return with an input impedance of 10 kOhm which will slightly vary with the master fader settings.
12.0 POWER/FUSE
The power supply is primarily fused between the power supply cable and the power supply transformer.
For 220 Volt use the value is slow 3.15 Amp.
For 110 Volt use the value is slow 6.30 Amp.
Clubmix manual page 10