1010music Laserbox 사용자 설명서 - 페이지 2

{카테고리_이름} 1010music Laserbox에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010music Laserbox 3 페이지.

Laserbox Modes

Laserbox supports several different modes for generating laser projection signals:

PATXYZ Oscillators generate values for Cartesian coordinates (X and Y) to drive a pattern. You can choose different waveforms to

control the X and the Y position of the laser over time. You can then modulate the frequency, amplitude and phase of each

waveform.

PATRAZ Oscillators generate values for Polar coordinates (radius and angle) to drive a pattern. You can choose independent

waveforms to control the radius and the angle of the laser over time. You can then modulate the frequency, amplitude and

phase of each waveform

WAVE

Laserbox gets the signal for the coordinates from a WAV file. You will have to use a third party tool to create the WAV file.

LIVE

Laserbox takes in CV signals for X, Y, R, G and B and uses these to generate the output signal.

In all of these modes, laserbox also lets you control the color, position, scale and rotation of the signal. You can use external Control

Voltage signals and internal LFOs to modulate the parameters for each of these, or manually dial in the values using the control knobs.

Laserbox displays a preview of the projection on the home screen and on all of the parameter screens, so you can immediately see the

impact of the changes you are making.

Waveforms for PATXYZ and PATRAZ Modes

When you are using PATXYZ or PATRAZ mode, the home screen will display an either a PATXYZ or PATRAZ button, to match the

selected mode. Touch this button to display the first Oscillator parameters screen. Press the INFO button to cycle through the

oscillators for the selected mode. In PATXYZ mode, there will be oscillators for the X and the Y coordinates. In PATRAZ mode, there

will be oscillators for the Radius and the Angle. You can configure the following parameters for each oscillator:

Waveform

•

Frequency (can be modulated)

•

Amplitude (can be modulated)

•

Phase (can be modulated)

•

Press HOME when you are ready to return to the Main screen.

WAV File Selection

When you are using WAVE mode, the home screen displays a WAVE button. Touch this button on the main screen to choose the

wave file to be used. Touch the name of the wave file in the top of the screen to display the file selection window. Choose a WAV file

from the microSD card by scrolling through the choices with the control knobs and then touching Load. Press HOME to return to the

main screen.

Live Mode Inputs

When you are using LIVE mode, you will need to connect two CV signals into toolbox. Use mini TS cables to connect the signals as

follows:

Toolbox Input

CV1

CV2

Laserbox takes a +/- 5 Volt control voltage signal as input. The X and Y values input through these signals provide a starting point for

the calculations used to control the outputs to the laser. The Color, Position, Scale and Rotation parameters of laserbox are combined

with the input signals to generate the output to the laser.

12/12/18 5:16 PM

Laser Signal

Laserbox User Guide p. 2