Asko TD60.C 서비스 매뉴얼 - 페이지 15

{카테고리_이름} Asko TD60.C에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko TD60.C 19 페이지. Professional td
Asko TD60.C에 대해서도 마찬가지입니다: 서비스 매뉴얼 (19 페이지)

Service Manual TD60.C

Fault indicators

Error message

Over Flow

Max program

time

Clean filter

Clean condenser

Thermistor fault

Cause

• A micro switch is opened when a full conden-

sed water tank is detected. Detection begins 30

seconds after the programme starts. If the micro

switch

is open >30 seconds the programme cycle is

stopped.

• The programme cycle time exceeds 200 minutes.

The cycle is stopped and the programme is reset.

• High ambient temperature combined with low

heater output and low drying temperature causes

condensation to form.

• Poor condensing due to blocked external air.

• Indicated when the air flow and temperature do

not match.

• Displayed automatically every 100 cycles.

• Displayed if the machine has indicated "Clean

filter" twice in a row.

• Thermistor circuit open.

• Thermistor malfunction.

Action

• Check that the customer has emptied the tank and

restarted the machine.

• Clean hoses and check voltage and resistance of

drainage pump.

• Check that the float has not got "stuck" and check the

function of the micro switch.

• Tried spinning at a higher speed.

• Had the machine switched off for 30 minutes

before restarting.

• Good ventilation in the room.

• Ensure that the external air has free passage.

• Clean the filter.

• Clean condenser and filter.

• Clean other air passages.

• Check the thermistor.