Ambiductor HEAT 1 작동 및 장착 지침 매뉴얼 - 페이지 10
{카테고리_이름} Ambiductor HEAT 1에 대한 작동 및 장착 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambiductor HEAT 1 20 페이지.
페이지 인쇄
ID
Parameter
3.11*
Tarif 1
3.12*
Tarif 2
3.13*
Pulse in/output 1 configuration
3.14*
Pulse in/output 2 configuration
3.15
Type of heat-conveying liquid
3.16
Pressure value for energy
calculations
3.17*
Customer number
Ambiductor AB reserves the right to make changes without prior notice. Reprinting or copying this publication without permission is prosecuted.
Value
°C
Tariff 1, at T1-T2 < 10,0
INT
BIL
INF
°C
Or > 10,0
INT
BIL
INF
°C
Or between 10,0...40,0
INT
BIL
INF
INT
BIL
INF
Or in time interval in hours
(00...24h)
INT
BIL
INF
Or tarif activated by pulse input:
INT
BIL
INF
See menu 3.11 but with L2
instead of L1.
Input:
INT
BIL
INF
Input (tariff activated):
INT
BIL
INF
Output: energy, volume
INT
BIL
INF
Tarif
INT
BIL
INF
INT
BIL
INF
Tarif mode:
INT
BIL
INF
See menu 3.13 but with "2"
instead of "1".
INT
BIL
INF
INT
BIL
INF
INT
BIL
INF
10
Description
It is possible to choose:
One of the measured parameters, 1st or 2nd pulse input
(if it is configured as an input), one of the temperature or
the temperature difference.
See menu 3.11.
Inputs:
Can be configured only for a quantity of water. Maximum
pulse resolution is displayed 0.00001 m3.
Outputs:
Can be configured for a quantity of water (m3), for hea-
ting (In a shown case) / cooling(additional snowflake is
displayed) energy or to one of tariffs.
See menu 3.13.
Type of heat-conveying liquid:
"---" (crosses)
- water
"160E4"-corresponds to the pressure 1.6 MPa.
Are transferred on telegram Mbus.