Ambient NanoLockit 매뉴얼 - 페이지 10

{카테고리_이름} Ambient NanoLockit에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient NanoLockit 19 페이지. Timecode + logging
Ambient NanoLockit에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (20 페이지), 빠른 시작 매뉴얼 (5 페이지), 매뉴얼 (4 페이지), 튜토리얼 (5 페이지), 빠른 매뉴얼 (2 페이지)

5.3 TX Mode (Transceiver Mode)

The TX Mode basically works like the C-Jam Mode, with the difference that

the TX Master receives timecode and frame rate from an external source via

cable. Main use cases are playback situations (e.g. music video shootings).

To start the unit as TX Master press and hold

Red, then tap

Power.

As soon as the external source sends timecode, the TX Master will broadcast

it via ACN to all other Lockits. They will display an ACN icon at the lower right

of the display.

As soon as the external source stops sending timecode to the TX Master, the

timecode on all Lockits will freeze, and they will start flashing yellow. As soon

as the timecode starts running again, they'll flash green again.

Note: to make the TX Mode work, all Lockit Devices must run

on the latest firmware. (7.xx)

5.4 ACN Receiving Mode

All Lockit devices that are jammed via a C-Jam or TX Master automatically

switch to ACN Receiving Mode, indicated by the ACN logo in the lower right of

the display.

Lockit devices in ACN Receiving Mode constantly follow the current C-Jam or

TX Master.

Power.

To power up just long-press

Lockit devices that are powered up at a later point of time will automatically

switch to ACN Receiver Mode after having received a jam via ACN. Their time-

code and frame rate will be set accordingly.

Lockit Users manual |