Ambient Recording ACD 201 매뉴얼 - 페이지 9

{카테고리_이름} Ambient Recording ACD 201에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Recording ACD 201 20 페이지.

2 . 3 The Manual Set Mode

To enter the SET MODE press both (RED and BLUE) buttons simultaneously for

appr. 3 seconds until the userbits show (one spacer dot). The left most digit will

blink. You can then release both buttons. The digits can be changed with the

following cursor movements:

2.3.1 Moving the Cursor

To move Right

To move Left

Increment value

Decrement value Hold down RED button and decrement with BLUE.

Closing the slate stick at any time during the set mode immediately cancels

all the current changes and reverts the slate to the state prior to the set mode.

Note: The generator still counts during set mode so no time is lost by entering

and leaving set mode in the above manner.

Diagram of cursor ring

The cursor moves in ring in the following way:

First 8 user digits ( single spacedots) then a position one digit to the right of

the 8 userbits (pos 9) where the single spacerdots blink and the old and new

userbits can be toggled to select. Then on moving the cursor one more step

to the right the time display is entered (double spacerdots). Moving the cursor

to the right leaves the time display through the Toggle position (pos 18) and

reenters the userbit field from the left. The cursor can move in both directions

to reach its required position though the left to right movement is easier to

implement with the push buttons and considering one changes userbits more

often then the time.

Note: The position of the cursor decides which new Data is entered into the

With the cursor in the userbit or toggle userbit position, only

userbits will be entered into the generator. The time which still runs in the set

mode, will not have been changed.

With the cursor in the Time or toggle time position the selected time

and Userbits will be entered into the generator.

Loading the selected values into the generator is implemented by holding

down both buttons simultaneously till the display runs.

Press the BLUE button.

Hold the BLUE button down and press the RED button.

Push RED button.

generator.

virtual