Asko W6424 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Asko W6424에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko W6424 8 페이지. Domestic

페이지 인쇄

Installation

Connection to water supply

Hot water connection (depending on model)

A few seconds after you start a program, the

washing machine will begin to ﬁ ll with water from

the hot and cold supplies. If for some reason no

hot water is available, the machine waits for one

minute and then ﬁ lls with cold water only. The

wash drum does not start to rotate until it begins

to ﬁ ll with water.

However, if you choose to connect your ECO-

machine to cold water only, it is important that

you shut oﬀ the hot water connection.

See the "Settings" chapter for information on

how to switch between "Hot water On" and "Hot

water Oﬀ ".

Read these instructions carefully and

completely before you install themachine. The

installation should be carried out by a qualiﬁ ed

person who is familiar with all local codes

and ordinances for electrical and plumbing

connections. Cosmetic damage must be

reported to your dealer within ﬁ ve days from the

date of purchase. After unpacking the washer,

thoroughly check the unit for cosmetic damage.

Leveling the machine

It is important that the machine is level to

prevent excessive vibrations during spin cycles.

Each foot of the washer is adjustable, so you

can level the washer on any surface.

Once it is level, securely tighten the lock nuts

on the feet to prevent excessive vibration during

spin cycles.

Be sure to tighten the

lock nuts securely

when you level the

machine.

Water supply connection

Since ASKO washers have a built-in heating

element, you only need a cold water inlet. The

connection should be made by someone who

is suﬃ ciently skilled. Use the hose supplied

with the washer. (The inlet hose is marked for

correct connection.) The water pressure must

be in the range 15–146 PSI. A valve should be

ﬁ tted on the water supply pipe. If a new supply

pipe has been installed for the washer, it should

be ﬂ ushed thoroughly to remove any foreign

particles that might clog the ﬁ lter in the ﬁ ll valve.

NOTE!

If the unit is installed on a second storey, follow

local building codes. We recommend installing a

drip pan.