1010music Bitbox mk2 빠른 시작 매뉴얼

{카테고리_이름} 1010music Bitbox mk2에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010music Bitbox mk2 4 페이지.

페이지 인쇄

The bitbox mk2 2.2 Quick Start Guide

SET UP

1. Insert the microSD card into the MICRO SD slot, notched edge away from the screen.

2. Turn off your Eurorack and use the ribbon cable to connect the module to power:

■ Attach to the module with red edge of the ribbon cable on the left

side of the module when module is held with power socket on top

edge of module.

■ Attach to the Eurorack +12V power supply, with the red edge of the

cable aligned with pin 1 or the -12V pins on the power supply bus.

3. Mount the module into the rack and then power it up.

4. Connect your bitbox mk2 to external gear:

▪Out1 & Out2: connect to your mixer or speakers.

▪In1 & In2: connect to left and right audio signals to record.

▪MIDI: connect to a MIDI controller to trigger pads, play pads

chromatically, follow a MIDI clock, or use MIDI CC to control

parameters.

GET STARTED

When bitbox mk2 powers up, you see the Pads Screen. Touch a pad to trigger it. Use the

knobs to select elements and assign values. Push the HOME button to open the Menu

screen.

CLOCK

Beats : bars

PADS

Touch to

trigger.

NOTE:

■ The bitbox mk2 does not automatically save your changes. Any unsaved changes

will be lost when you load a preset or power down the module. Push the HOME

button until you see the Menu screen, touch Presets, and then touch Save to

commit the changes to the preset.

SELECTED PAD

Touch a pad or turn a

knob to change selection.

Pads

PROGRESS BAR

Bar is white

when waiting for

quantization

break to start

Touch to

playback.

select an

option.

MODULATION

SOURCE

Shows state of

CV input.

The bitbox

mk2 requires

400mA on the

+12V rail only.

The bitbox

mk2 supports

Type A and

Type B TRS

MIDI In.

FIRMWARE

VERSION

Page 1