Ambient Technologies TSMT 사용 설명서 - 페이지 4

{카테고리_이름} Ambient Technologies TSMT에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Technologies TSMT 9 페이지. Touch screen manual timer

페이지 인쇄
Make sure that the wires do not contact the appliances any place other than at the ter-
minals. Exposure to temperatures higher than 105° C (250° F) may cause the receiver
to malfunction or fire hazard.
Transmitter
n Function Areas of the LCD Display
The figure on the right shows the display of the TSMT LCD.
Information Bar
The information bar shows the room temperature, the "sending signal" radio
icon, the low battery indication icon, the child-proof icon, and the flame icon.
This area doesn't have touch buttons.
•
The room temperature will always be shown after power-up. It displays
the room temperature from 40 °F to 99 °F. "Lo" and "HI" will be dis-
f i r e - p a r t s . c o m
played when the room temperature is lower than 40°F or higher than 99°F,
respectively.
•
The radio icon will be shown when the transmitter is sending a signal.
•
The low battery indication icon will be shown when the battery voltage is
low.
•
The child-proof icon will be shown when the child-proof mode is acti-
vated.
•
The flame icon indicates the current fireplace status – On or Off.
Touch Area
The touch area contains all touch buttons to control the transmitter. It consists of two categories:
menus and adjustment arrows. The blue LED backlight lights up for 8 seconds when any of the
touch buttons is pressed.
•
The menu contains the TIMER button.
•
The adjustment arrows include ON/up and OFF/down. Their default function is to turn on/off
the flame. When a button from the menu is pressed, the ON/up and OFF/down buttons will
temporarily become adjustment controls for the selected item. When the adjustment is done,
the ON/up and OFF/down buttons go back to flame controller again.
Logo Bar
The Logo Bar contains the brand logo: Ambient Technologies.
n Initialization and Setting up
Installing Batteries:
The remote transmitter has two battery compartments, one on each end of the transmitter. Always change all four
(4) batteries at the same time.
Page:
Touch Screen Transmitter Manual Timer Instructions
Function Areas of the LCD Display
FP2606

LCD display

Battery Door
Tabs
FP2607

install battery

20300538