Ambient Weather WS-1172 사용자 설명서 - 페이지 3

{카테고리_이름} Ambient Weather WS-1172에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Weather WS-1172 17 페이지. Advanced weather station

2.4 Display Console Set Up

Note: To avoid permanent damage, please take note of the battery polarity before inserting the

batteries.

Move the remote thermo-hygrometer at least 10' away from the display console (if the sensor is too

close, it may not be received by the display console).

Remove the battery door on the back of the display. Insert three AA (alkaline or lithium, avoid

rechargeable) batteries in the back of the display console. Looking at the back of the unit (left to right),

the polarity is (+) (-) for the top battery, (-) (+) for the middle battery and (+) (-) for the bottom battery.

The display will beep once and all of the LCD segments will light up for a few seconds to verify all

segments are operating properly.

Replace the battery door, and fold out the desk stand and place the console in the upright position.

The console will instantly display indoor temperature, humidity, barometer, tendency, date and time.

The outdoor temperature and humidity will update on the display within a few minutes. Do not touch

any buttons until the remote sensor reports in, otherwise the remote sensor search mode will be

terminated. When the remote sensor data has been received, the console will automatically switch to

the normal mode, and all further settings can be performed.

If the remote does not update, please reference the troubleshooting guide in Section 7.

The RCC is received by the remote sensor and transmitted to the main console to improve reception.

After the remote sensor is powered up, the sensor will transmit weather data for 30 seconds, and then

the sensor will begin radio controlled clock (RCC) reception. During the RCC time reception period

(maximum 10 minutes), no weather data will be transmitted to avoid interference.

If the signal reception is not successful within 1 minute, the signal search will be cancelled and will

automatically resume every two hours until the signal is successfully captured. The regular RF link

will resume once RCC reception routine is finished. In some locations, it may take a couple of days to

receive the radio control signal.

Version 1.0

Figure 1

Page 3