Ambient Weather RC-1200BWDN 사용자 설명서 - 페이지 7

{카테고리_이름} Ambient Weather RC-1200BWDN에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambient Weather RC-1200BWDN 8 페이지. Radio controlled analog wall clock

페이지 인쇄

Problem

Radio controlled clock does not update or

time is wrong.

The clock is off by increments of an hour.

The clock does not respond to commands.

15 Liability Disclaimer

Reading the "User manual" is highly recommended. The manufacturer and supplier cannot accept any

responsibility for any incorrect readings and any consequences that occur should an inaccurate reading

take place.

This product is not to be used for medical purposes or public information.

The specifications of this product may change without prior notice.

This product is not a toy. Keep out of the reach of children.

No part of this manual may be reproduced without written authorization of the manufacturer.

Ambient, LLC WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL,

PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR

MALFUNCTION OF THIS PRODUCT.

This product complies with the applicable national and USA and European regulations. All rights

Version 1.1

Solution



Hang the clock on a wall. Laying the clock flat

on a surface will result in poor reception.



Be patient. Wait at least one week before

contacting Ambient Weather. The RCC is a

shortwave signal originating near Fort Collins,

Colorado, and travels thousands of miles by

bouncing off the ionosphere. The signal is better

at night due to solar interference during the

daytime. The farther you are from Colorado, the

weaker the signal. Urban environments can also

affect the signal strength.



Locate the Clock at night near a window or

outer wall, and away from other radiating

sources, like wireless routers or TVs. This will

insure the best reception possible.



Replace the batteries in the clock if

required. Low batteries are often the cause for

weak reception.



Check your Time Zone Setting. Make sure

your time zone is set properly in the clock

settings.



Avoid closed in areas. Closed in areas such as

basements are not recommended.



Check your Time Zone and DST

Settings. Make sure your time zone and DST

switches are set properly.



Press the reset button on the back of the clock.

Page 7