ACR Electronics 2985 문제 해결 - 페이지 2
{카테고리_이름} ACR Electronics 2985에 대한 문제 해결을 온라인으로 검색하거나 PDF를 다운로드하세요. ACR Electronics 2985 2 페이지.
ACR Electronics 2985에 대해서도 마찬가지입니다: 테스트 (2 페이지)
페이지 인쇄
Troubleshooting
7. You should always try to install your Guardian at least
0.5 meters from any equipment transmitting radio
signals including VHF Radios, antennas and cables.
9. If a false alarm sounds again return to step 1 and increase the Alert Delay at step 5 in increments of 2 seconds.
If false alarms continue after 8 seconds an additional OLAS Extender is required to cover the signal 'black spot'.
Using an Extender will also allow you to reduce the 'Alert Delay' back done to the default of 2 seconds.
1m
Tom
Overboard!
Step 1
Press and hold the MOB button
on your GPS Chart Plotter
Step 2
Send a MOB DSC alert
using your VHF
Continue to recovery
Pause Alert Sound
www.acrolas.com
8.
If located within 0.5 meters it is possible false alarms may occur. If you
are experiencing false alarms try moving the Guardian hub away from
other electrical devices and then carry out the Guardian setup and
range test to see if the false alarms still occur.
0.75m extension leads are avaible for the Guardian control switch cable
and the Power and Signal wires.
Alert Settings
(Guardian/Core)
Solo Mode
Vessel
0438
Near
0438
Information
Alert Settings
Device Selection
FAQ's
Close OLAS
Sound
Firmware Update
Siren (Default)
Online
Tutorials
MOB
Volume
Alert Delay
2
seconds
Connected to
(Guardian only)
1m
Alert Settings
Sound
Siren (Default)
Near
Volume
Alert Delay
3
seconds
Pause Alert Sound
MOB
Connected to
(Guardian only)