AMBION FLAME EF-1510 SBP series 설치 및 사용자 지침 매뉴얼 - 페이지 4

{카테고리_이름} AMBION FLAME EF-1510 SBP series에 대한 설치 및 사용자 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMBION FLAME EF-1510 SBP series 6 페이지. Electric fireplace with remote control

페이지 인쇄

serial

name

number

001

Carton

002

Screws ( 4 x 8 mm)

003

Screws ( 4 x 35mm)

004

Fixed Angle

005

Plastic plug( 8 mm)

006

Packing left bubble

007

fireplace

008

bracket

009

Plastic plug( 8 mm)

010

Screws ( 4x35 mm)

011

remote control

012

Packing right bubble

013

Power cord

Helpful Advice Before Fitting

a) Please retain all packaging until you have checked and counted all the parts and the contents of

the fixing pack against the parts list.

b) The fixing pack contains small items which should be kept away from young children.

c) We suggest that you open the fixing pack and place all the contents into a container, therefore

reducing the risk of losing any small pieces.

Installation（Wall mounting）

a) Do not connect the appliance until properly fixed to the wall and the instructions is read fully.

b) The minimum distances must be observed.

c) For installation of the appliance, care must be taken not to damage concealed cables.

d) Please be careful while drilling the holes.

e) This appliance is designed to be permanently fixed to a wall at a minimum height of 18". The

wall bracket must be fitted horizontally and the cable routed to the bottom right of the heater.

A height of 36" from bottom of heater to floor is recommended for optimum viewing of fuel

bed（see fig.1 for recommend fixing dimensions）.

g) Use the bracket as table template and mark five drill positions on the wall. Make sure that these

holes are level. Observe the recommended fixing dimensions (Fig. 2).

h) Put the bracket aside and drill holes with a depth of 1" using an 8 mm drill bit.

Clean the holes from dust and insert one plug in each hole. Make sure the edge is flush with the

surface.

quantity