1010music MX4 사용자 설명서

{카테고리_이름} 1010music MX4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010music MX4 2 페이지.

페이지 인쇄

Overview

The MX4 by 1010music serves a very simple but useful purpose. It takes in a single

MIDI input and repeats it in real time to four MIDI outputs, quadrupling the number

of modules that can be controlled from a single MIDI source.

The MX4 is a 3 HP module. It comes with 2 black stereo minijack cables and 2 black

and white MIDI adapters.

Connections Supported

The MX4 has 5 standard stereo minijacks connectors: 1 input and 4 output

connectors. The cables used to connect the MX4 to external devices will vary based

on the connections supported by the other device.

MIDI 5 Pin DIN to Stereo Minijack

The standard MIDI connector is the MIDI 5 Pin DIN connector. Use the black and

white MIDI adapters provided with the MX4 to connect to these devices. Not all

MIDI adapters are the same, so be sure to use the adapters provided or adapters

that meets the Technical Specs below. You can buy more 1010music compatible

MIDI adapters on our website: www.1010music.com.

Stereo Minijack to Stereo Minijack

The MIDI industry has not standardized on how to map the MIDI signal to the stereo

minijack connectors. As a result, not all MIDI devices with stereo minijack

connectors support connection using the provided black stereo minijack cables.

The MX4 uses a minijack connection that is known to be compatible with the

following:

Products Compatible with the Stereo Minijack Cables

1010music products

•

IK Multimedia products (such as iRIG MIDI)

•

Novation products (such as Launchpad Pro)

•

Arturia BeatStep Pro

•

Products that use an alternative signal mapping for the minijack connections cannot use the

included black stereo minijack cables. Instead, these products can be connected by means of a

pair of MIDI adapters. Use the black and white MIDI adapters provided with the MX4 to connect

to the MX4 jacks, then use the appropriate MIDI adapter to connect to the external device. The

following products are known to require a MIDI adapter:

Products that Require a MIDI Adapter:

Korg products

•

Make Noise 0-Coast

•

Arturia BeatStep (not to be confused with the BeatStep Pro)

•

ADDAC System products

•

See the Technical Specifications below for more details about the connectors used by 1010music

products.

If your device isn't listed above, how can you tell if the stereo minijack connector on your MIDI

device is compatible? Compare the technical specifications below with those provided with the

external device, or just try it out. Either it will work or it won't. Attempting to connect with

incompatible cables should not damage devices designed in accordance with the MIDI spec.

7/31/17 3:35 PM

MX4 User Guide