ambiq micro Apollo3 Blue EVB 빠른 시작 매뉴얼 - 페이지 11

{카테고리_이름} ambiq micro Apollo3 Blue EVB에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ambiq micro Apollo3 Blue EVB 14 페이지. Board revision 1.0

Software Development Tools

The standard Segger J-Link debug interface is used on the Apollo3 Blue EVB. Please install the latest Beta

Segger J-Link software, and configure your preferred development IDE (Keil, IAR, or Eclipse) to use J-Link

debug interface.

Links to development tools that support Apollo3 Blue (AMA3B1KK-KBR):

▪

SEGGER J-Link Software (6.33h Beta or later)

▪ KEIL uVision (MDK523 or later):

▪ New Keil Pack (Also used by Eclipse):

▪ IAR Version 7.80.4 (8.10.1 or later):

cortex-m-edition/

▪ GCC 5.3.1:

https://gcc.gnu.org

Regardless of preferred IDE, please install the Segger J-Link software. All of the above development

environments support J-Link, but you must have the latest J-Link software installed. Most alternate

development environments also are supported by J-Link.

Please refer to the AmbiqSuite Getting Started Guide (AMSDKGS) at

uploads/2017/09/AMSDKGS-v1_1.pdf

QS-A3B-1p00

https://www.segger.com/downloads/jlink

https://www.keil.com/demo/eval/arm.htm

http://www.keil.com/dd2/pack/#/third-party-download-dialog

https://www.iar.com/iar-embedded-workbench/tools-for-arm/arm-

for more details on setting up development IDEs to use J-Link.

Page 11

Apollo3 Blue EVB Quick Start Guide

https://ambiqmicro.com/wp-content/

2018 Ambiq Micro, Inc.