Ambir nScan 1060 설치 및 설정 매뉴얼 - 페이지 10

{카테고리_이름} Ambir nScan 1060에 대한 설치 및 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ambir nScan 1060 16 페이지. High-speed adf scanner

Maintenance and Troubleshooting:

Calibration with a PC

Calibrate the scanner when colors appear in areas that should be white, or colors of the scanned

image and the original vary, or degraded image quality. Calibration allows you to compensate for

normal variations that can occur in the optical components over time.

Note: If you lose the calibration sheet or the calibration sheet is damaged, contact Ambir support.

24.

Use the included calibration sheet to calibrate the scanner. The calibration sheet is

marked with arrows on the long edges and is specifically designed for calibrating your scanner.

25.

Insert the special calibration sheet into the ADF, with the one of the arrows pointing into the ADF.

26.

Click Start > All Programs > Ambir ImageScan Pro scanner > Calibration Wizard.

27.

Click Next from the Calibration Wizard that pops up, then click Calibrate Now.

28.

Click Start to begin the calibration process.

click OK and then click Finish.

Use the following cleaning materials to clean the scanner:

 Non-abrasive cleaning fluid: Isopropyl rubbing alcohol (95%)

Important: Do not use water to clean the ADF.

29.

Open the ADF cover by pulling the cover lever.

30.

Gently wipe the following areas with the cloth dampened with cleaner. Be careful

NOT to scratch their surfaces.

Cleaning the Feed Roller:

Wipe the Feed Roller from side to side and then rotate it.

Repeat until then entire roller is cleaned.

Cleaning the Pad Module:

Wipe the Pad Module from top to bottom (in the direction of arrow shown in below picture). Be careful

not to damage the pick springs of the pad.

Wait for cleaned areas to dry completely.