Asko D1796FI 기획 및 디자인 매뉴얼 - 페이지 14

{카테고리_이름} Asko D1796FI에 대한 기획 및 디자인 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Asko D1796FI 15 페이지. Standard dishwashers
Asko D1796FI에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (2 페이지), 설치 및 사용자 지정 (4 페이지), 기획 및 디자인 매뉴얼 (19 페이지), 사용 및 관리 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (14 페이지)

FILL STRIPS INSTALLATION INSTRUCTIONS

Attaching Side Fill Strips

1. If you are installing the dishwasher with the side fill strips, you must remove the

insulation strips. These are the black sponge strips attached to the front edge of the

tank, from top to bottom. To remove them, simply grip the top or bottom edge and pull

it away from the tank, as illustrated in Figure 6.

2. The trim strip has multiple mounting holes. Align the largest hole with the same size

hole on the side of the dishwasher, as illustrated in Figure 7. (This hole is used when

you anchor the dishwasher to the cabinet.)

3. Keeping the trim strip aligned with the holes, open the dishwasher door and secure it

to the dishwasher with the screws provided, as illustrated in Figure 8. (The screw head

should be inside the tank.)

4. When anchoring the dishwasher to the cabinet, height adjustments is essential to

properly align the panel with the cabinet facings.

NOTES:

Be sure to order a side fill strip for each side (left and right).

The unit will accept various sized panels. Refer to the dishwasher specifications before

building the panel so it will correctly align with the cabinet facings.

If a four-inch toe kick is used, the unit must be installed at its lowest height. (The

dishwasher is delivered at its lowest height.) On four-inch toe kick installations, the

one-piece door panel will extend past the top of the control panel approximately 1-3/4".

Specifications are subject to change without notice. See installation instructions for additional details.

ASKO D

ISHWASHER

Figure 6.

Figure 7.

Figure 8.